Precautions for Switching on and off Sequence of Metal Plate Fiber Laser Cutting Machine

Reading Time: 3 minutes

One of the main reasons for the failure of the metal plate fiber laser power supply is the internal condensation of the laser, which is closely related to the daily bad habits of customers when operating and using metal plate fiber lasers. To reduce the failure rate of metal plate fiber lasers and reduce losses caused to customers due to the shutdown of metal plate fiber laser cutting machines, attention should be paid when using metal plate fiber laser cutting machines.

Startup sequence of metal plate fiber laser cutting machine

  1. Check if there are any items within the operating range of the machine tool that affect safe operation;
  2. Turn on the main power switch and each branch control power switch of the metal plate fiber laser cutting machine;
  3. Turn on the voltage regulator and check whether the voltage regulator operates normally;
  4. Turn on the power switch of the metal plate fiber laser and then turn on the key switch, allowing the metal plate fiber laser to run for more than 30 minutes with its own air conditioning or internal defroster;
  5. Turn on the air compressor when the power switch of the metal plate fiber laser is turned on for 20 minutes, and check whether the air compressor operates normally;
  6. Open the control valve of the air circuit, turn on the cold dryer, and check whether the cold dryer operates normally and whether the air pressure is normal;
  7. According to the cutting needs, open the cutting auxiliary gas control valve and check whether the cutting auxiliary gas pressure is normal;
  8. Turn on the power switch of the machine tool, press the power on button to start the machine tool control system, and wait for the control system to start normally before the machine tool returns to its original position;
  9. Turn on the chiller after the power switch of the metal plate fiber laser has operated for more than 30 minutes, and check whether the chiller operates normally;
  10. After the actual temperature of the high and low temperature water of the chiller reaches the set temperature difference of one degree, high pressure is applied to the metal plate fiber laser, and check whether the metal plate fiber laser operates normally; one
  11. Turn on the exhaust fan or dust remover, check whether the operation status of the exhaust fan or dust remover is normal, and the optical metal plate fiber laser cutting machine enters the state to be cut.
metal plate fiber laser cutting machine 1
metal plate fiber laser cutting machine 2
metal plate fiber laser cutting machine 3
metal plate fiber laser cutting machine 4

Share:

Facebook
Twitter
Pinterest
LinkedIn
Hello Customers

Hello Customers

I'm Jackson Cao, founder of prima-press, with over 30 years in the sheet metal industry. Our goal is to deliver valuable content related to sheet metal processing to a wider audience. Don't hesitate to get in touch—I'm delighted to offer top-tier service and products. Welcome to a world of premium sheet metal expertise!

Related Posts